BMW X5 F15 (2014-2019) won't remote start what might be causing it

BMW X5 F15 (2014-2019)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

460 words

Problem Statement

The BMW X5 F15 (2014-2019) is experiencing issues with remote starting, which may be attributed to various electrical or system-related malfunctions.

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical components to prevent shorts.

Symptoms

•Remote start feature is non-functional
•Key fob not responding to remote start commands
•Dashboard displays error messages related to the key or engine
•Engine does not crank when attempting to remote start
•Security system activation preventing remote start

Diagnostic Steps

1
Check the battery status of the key fob to ensure it has sufficient charge.
2
Scan the vehicle’s system using an OBD-II scanner for any diagnostic trouble codes (DTCs).
3
Inspect the vehicle's battery for adequate voltage and connections.
4
Verify the functionality of the remote start system via the vehicle settings menu.
5
Check for any active security system alerts or immobilizer issues.
6
Inspect the hood latch switch to ensure it is functioning correctly.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Multimeter
•Small flathead screwdriver

Parts Required

•CR2032 key fob battery
•Replacement hood latch switch (if found defective)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check the battery status of the key fob to ensure it has sufficient charge.
2
Scan the vehicle’s system using an OBD-II scanner for any diagnostic trouble codes (DTCs).
3
Inspect the vehicle's battery for adequate voltage and connections.
4
Verify the functionality of the remote start system via the vehicle settings menu.
5
Check for any active security system alerts or immobilizer issues.
6
Inspect the hood latch switch to ensure it is functioning correctly.

Solution

1. Preparation

Gather tools and parts.
Ensure the vehicle is parked in a well-ventilated area.
Disconnect the battery to avoid electrical shorts.

2. Key Fob Battery Replacement

Remove the key fob cover using a small flathead screwdriver.
Replace the old battery with a new CR2032 battery, ensuring correct polarity.
Reassemble the key fob and test the remote start function.

3. Battery Inspection

Use a multimeter to check the vehicle battery voltage (should be around 12.6V).
If voltage is low, jump-start the vehicle or replace the battery if necessary.
Inspect battery terminals for corrosion and tighten connections.

4. Inspect the Hood Latch Switch

Locate the hood latch switch, typically found near the hood release mechanism.
Disconnect the wiring harness from the switch.
Use a multimeter to test for continuity; replace the switch if it does not function properly.

5. Resetting the Vehicle's Security System

Reconnect the vehicle battery.
Use the key fob to lock and unlock the doors several times to reset the security system.
Attempt to remote start the vehicle again.