how to reset the transmission fluid light on my Ford Explorer Fifth Generation (2011-2019)

Ford Explorer Fifth Generation (2011-2019)

Error Codes

10-15 minutes

Time

easy

Difficulty

medium

Severity

2 min read

378 words

Problem Statement

Learn how to reset the transmission fluid light on your Ford Explorer Fifth Generation (2011-2019) with this step-by-step guide. Ensure proper maintenance.

Affected Component

Transmission

Estimated Time

10-15 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always ensure the vehicle is in 'Park' or 'Neutral' before performing any reset procedures.

Symptoms

•Transmission fluid light illuminated on the dashboard
•Unresponsive transmission fluid level gauge
•Previous maintenance performed related to transmission fluid
•Warning message displayed on the driver information center regarding transmission maintenance

Diagnostic Steps

1
Ensure the vehicle is parked on a level surface and the engine is turned off.
2
Turn the ignition key to the 'On' position without starting the engine.
3
Press the gas pedal three times within 5 seconds.
4
Check the dashboard for the transmission fluid light status.
5
If the light remains on, check the transmission fluid level and condition.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Owner's manual

Parts Required

•None for resetting the light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is parked on a level surface and the engine is turned off.
2
Turn the ignition key to the 'On' position without starting the engine.
3
Press the gas pedal three times within 5 seconds.
4
Check the dashboard for the transmission fluid light status.
5
If the light remains on, check the transmission fluid level and condition.

Solution

1. Preparation

Gather necessary tools: OBD-II scanner (if needed), owner's manual.
Ensure the vehicle is on a flat surface.
Disconnect the battery (optional for safety).

2. Access the Transmission Fluid Light Reset

Turn the ignition key to the "On" position without starting the engine.
Ensure all accessories are turned off to avoid interference.

3. Reset the Transmission Fluid Light

Press and release the gas pedal three times within 5 seconds.
Observe the dashboard for any changes in the transmission fluid light status.
If the light goes off, the reset is successful.

4. Confirm Operation

Start the engine and allow it to run for a minute.
Check that the transmission fluid light does not illuminate again.