how to reset the oil change light on Ford Explorer Sixth Generation (2020-present)

Ford Explorer Sixth Generation (2020-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

349 words

Problem Statement

Learn how to reset the oil change light on your 2020-2023 Ford Explorer. Step-by-step guide to ensure accurate maintenance tracking.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park and the parking brake is engaged before performing the reset.

Symptoms

•Oil change light illuminated on the dashboard
•Maintenance reminder message displayed
•No other engine warning lights present

Diagnostic Steps

1
Turn the ignition switch to the 'On' position without starting the engine.
2
Use the accelerator pedal to press down three times within ten seconds.
3
Observe the oil change light and check if it blinks or turns off.
4
Turn the ignition switch off and then back on to confirm the reset.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required for the reset process.

Parts Required

•None required for the reset process.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a level surface.
Engage the parking brake for safety.

2. Turn the Ignition On

Insert the key or press the start button to turn the ignition to the "On" position without starting the engine.

3. Press the Accelerator Pedal

Firmly press the accelerator pedal to the floor three times within ten seconds to trigger the reset process.

4. Confirm Reset

Observe the oil change light on the dashboard. If it blinks and then goes off, the reset was successful.

5. Turn Off Ignition

Turn the ignition switch off completely to finalize the reset process.

6. Restart the Vehicle

Start the engine to ensure that the oil change light remains off.