how to reset the oil change light on my Ford Explorer

Ford Explorer Sixth Generation (2020-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

343 words

Problem Statement

Learn how to reset the oil change light on your Ford Explorer with this step-by-step guide. Quick and easy instructions for a successful reset.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park before performing the reset.

Symptoms

•Oil change light illuminated on the dashboard
•Maintenance reminder notification displayed
•Engine oil level is adequate after service

Diagnostic Steps

1
Turn the ignition key to the 'On' position without starting the engine.
2
Press the gas pedal three times within five seconds.
3
Observe the oil change light; it should flash and then turn off.
4
Turn off the ignition and wait a few seconds.
5
Turn the ignition back to the 'On' position to confirm the reset.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None specifically required for the reset process.

Parts Required

•None required for the reset process.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition key to the 'On' position without starting the engine.
2
Press the gas pedal three times within five seconds.
3
Observe the oil change light; it should flash and then turn off.
4
Turn off the ignition and wait a few seconds.
5
Turn the ignition back to the 'On' position to confirm the reset.

Solution

1. Preparation

Ensure the vehicle is parked on a level surface.
Gather necessary tools (if any required for your specific model).

2. Ignition Position

Insert the key into the ignition or press the start button (depending on the model).
Turn the ignition to the "On" position without starting the engine.

3. Reset Procedure

Quickly press the gas pedal three times in succession within five seconds.
Watch for the oil change light to blink and then turn off, indicating the reset was successful.

4. Confirmation

Turn off the ignition completely.
Wait for approximately 10 seconds.
Turn the ignition back to the "On" position and check that the oil change light is no longer illuminated.