my Ford Explorer makes a loud noise when I accelerate what's the issue

Ford Explorer Sixth Generation (2020-present)

Error Codes

2-4 hours

Time

medium

Difficulty

high

Severity

3 min read

433 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to diagnose and fix loud noise during acceleration in Ford Explorer. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Drivetrain

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before starting any inspections or repairs.

Symptoms

•Loud noise increasing with acceleration
•Possible vibration felt through the vehicle
•Loss of power during acceleration
•Engine stalling or misfiring
•Unusual smells (burning or fuel) during operation

Diagnostic Steps

1
Inspect the exhaust system for leaks or damage.
2
Check for loose or damaged engine mounts.
3
Scan for error codes using an OBD-II scanner.
4
Examine the drivetrain components, including the transmission and differential.
5
Test drive the vehicle to replicate the noise and assess under different conditions.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Wrench set
•Socket set
•Pry bar
•Flashlight
•Jack stands

Parts Required

•Engine mounts (if replacement is necessary)
•Exhaust system components (if damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the exhaust system for leaks or damage.
2
Check for loose or damaged engine mounts.
3
Scan for error codes using an OBD-II scanner.
4
Examine the drivetrain components, including the transmission and differential.
5
Test drive the vehicle to replicate the noise and assess under different conditions.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a flat surface and engage the parking brake.
Disconnect the battery to ensure safety during repairs.

2. Inspect Exhaust System

Tools Required: Wrench set, flashlight.
Visually inspect the exhaust pipes, muffler, and catalytic converter for any visible damage or rust.
If any leaks are found, mark the locations for repair or replacement.

3. Check Engine Mounts

Tools Required: Socket set, pry bar.
Locate the engine mounts and inspect for cracks or excessive wear.
Use a pry bar to gently check for movement in the mounts. If they are damaged, replace them with new mounts.

4. Examine Drivetrain Components

Tools Required: Jack stands, socket set.
Lift the vehicle using jack stands and inspect the transmission and differential for leaks or damage.
Check the condition of the driveshaft and CV joints for any signs of wear or failure.

5. Reconnect Battery and Test

Reconnect the battery and start the engine.
Test drive the vehicle to see if the noise persists after repairs.