why does my Ford Explorer Sixth Generation (2020-present) have a delayed start?

Ford Explorer Sixth Generation (2020-present)

Error Codes

2-4 hours

Time

medium

Difficulty

high

Severity

3 min read

464 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to diagnose and fix delayed start issues in Ford Explorer Sixth Generation (2020-present). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Electrical

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before attempting any repairs related to the starter motor.

Symptoms

•Engine cranks slowly before starting
•Extended time before engine turns over
•Clicking sound when turning the key
•Dashboard lights dim during start attempt
•Battery warning light illuminated

Diagnostic Steps

1
Check the battery voltage using a multimeter.
2
Inspect battery terminals for corrosion and tightness.
3
Test the starter motor by listening for engagement during start attempts.
4
Scan for any error codes using an OBD-II scanner.
5
Verify the condition of the ignition switch and wiring.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Multimeter
•Socket set
•Wire brush
•Screwdrivers

Parts Required

•New battery (if necessary)
•Starter motor (if necessary)
•Ignition switch (if necessary)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather all necessary tools and parts.
Disconnect the negative battery terminal.
Ensure the work area is safe and well-lit.

2. Battery Inspection and Replacement

Sub-step 1: Remove the battery cover if applicable.
Sub-step 2: Clean any corrosion from battery terminals using a wire brush.
Sub-step 3: Check the voltage; if below 12.4 volts, consider replacing the battery.
Sub-step 4: If replacing, disconnect the positive terminal, then the negative terminal, and remove the battery.
Sub-step 5: Install the new battery by connecting the positive terminal first, then the negative terminal.

3. Starter Motor Inspection

Sub-step 1: Locate the starter motor (usually near the transmission).
Sub-step 2: Disconnect the electrical connectors from the starter.
Sub-step 3: Use a multimeter to test for voltage at the starter terminal during crank attempts.
Sub-step 4: If no voltage is present, check the ignition switch and associated wiring.
Sub-step 5: If voltage is present but the starter does not engage, replace the starter motor.

4. Ignition Switch and Wiring Check

Sub-step 1: Remove any panels covering the ignition switch.
Sub-step 2: Inspect wiring for damage or loose connections.
Sub-step 3: Test the ignition switch using a multimeter for continuity.
Sub-step 4: Replace the ignition switch if it fails the continuity test.