how to fix P0011 code on Ford F-150 12th Generation (2009-2014)

Learn how to diagnose and fix P0011 camshaft position timing issue in Ford F-150 12th Generation. Step-by-step guide with diagnostic procedures and repair instructions.

Solution

1. Preparation

• Gather necessary tools and parts.
• Disconnect the battery before starting work.
• Ensure the vehicle is on a flat surface and secure with jack stands if needed.

2. Change Engine Oil and Filter

• Sub-steps:
  1. Drain the old engine oil by removing the oil drain plug with a socket set.
  2. Replace the oil filter using an oil filter wrench.
  3. Reinstall the drain plug and torque it to the manufacturer's specification (typically 20-25 lb-ft).
  4. Fill the engine with manufacturer-recommended oil type (typically 5W-20 for this model) through the oil filler cap.

3. Inspect and Replace VVT Solenoid

• Sub-steps:
  1. Locate the VVT solenoid on the engine (usually near the camshaft).
  2. Disconnect the electrical connector from the solenoid.
  3. Remove the mounting bolts using a socket set and carefully take out the solenoid.
  4. Install the new VVT solenoid and torque the bolts to specification (typically 80-100 in-lbs).
  5. Reconnect the electrical connector.

4. Inspect Timing Chain/Belt and Camshaft Position Sensors

• Sub-steps:
  1. Remove any necessary engine covers to access the timing chain/belt.
  2. Check for signs of wear or misalignment; replace if necessary.
  3. Using a multimeter, test the camshaft position sensor for proper resistance.
  4. If defective, remove the sensor and replace it, ensuring to torque the mounting bolts correctly.