how to reset the check engine light on Ford F-150 13th Generation (2015-2020)

Ford F-150 13th Generation (2015-2020)

Error Codes

30 minutes

Time

medium

Difficulty

medium

Severity

3 min read

403 words

Problem Statement

Learn how to reset the check engine light on Ford F-150 (2015-2020). Step-by-step guide with diagnostic procedures and tools required.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a stable surface before performing any diagnostics

Symptoms

•Check engine light illuminated
•Engine runs smoothly with no noticeable performance issues
•Recent repairs or maintenance performed on the vehicle
•No error codes present after a diagnostic scan
•Battery disconnected or replaced recently

Diagnostic Steps

1
Scan for error codes using OBD-II scanner
2
Inspect vehicle systems to ensure all are functioning correctly
3
Check for pending codes that might not yet have triggered the check engine light

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Vehicle owner manual

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required: OBD-II scanner, vehicle owner manual.
Ensure the vehicle is parked on a flat surface and the engine is off.

2. Connect the OBD-II Scanner

Locate the OBD-II port under the dashboard near the driver’s seat.
Plug the OBD-II scanner into the port.

3. Read and Clear Codes

Turn the ignition to the "On" position (do not start the engine).
Follow the scanner’s prompts to read any stored error codes.
If no codes are present or after addressing any codes, select the option to clear or reset the codes.

4. Disconnect the Scanner

Once the codes are cleared, safely disconnect the OBD-II scanner from the port.

5. Test Drive

Start the engine and take the vehicle for a short test drive to ensure the check engine light remains off.
Monitor any performance issues that may arise during the drive.