how to reset the check engine light on Ford F-150 14th Generation (2021-2024)

Solution

1. Preparation

• Gather necessary tools and equipment.
• Ensure OBD-II scanner is compatible with the Ford F-150.
• Turn off the vehicle and ensure it is in a safe, well-ventilated area.

2. Connect the OBD-II Scanner

• Locate the OBD-II port, typically found under the dashboard near the driver's side.
• Plug the OBD-II scanner into the port.

3. Retrieve Error Codes

• Turn on the ignition without starting the engine (key in the "ON" position).
• Follow the scanner's instructions to read and record any error codes.
• Note any codes that may require attention.

4. Clear the Check Engine Light

• On the OBD-II scanner, navigate to the option for clearing or erasing codes.
• Select the option and confirm to clear the codes.
• Wait for the scanner to confirm that the codes have been successfully cleared.

5. Disconnect the Scanner

• After clearing the codes, safely unplug the OBD-II scanner from the port.
• Ensure that the area is clear and that no tools are left in the vehicle.

6. Test the Vehicle

• Start the vehicle to check if the check engine light remains off.
• Allow the engine to idle for a few minutes and observe for any re-illumination of the light.