how to reset the electric power steering on a Ford F-150 14th Generation (2021-2024)

Ford F-150 14th Generation (2021-2024)

Error Codes

1 hour

Time

medium

Difficulty

high

Severity

3 min read

475 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to reset the electric power steering on a 2021-2024 Ford F-150. Step-by-step guide with symptoms, diagnostic steps, and tools required.

Affected Component

Steering

Estimated Time

1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems to avoid shorts or shocks.

Symptoms

•Steering wheel feels heavy or unresponsive
•"Power Steering Assist Fault" warning light illuminated
•Intermittent loss of power steering assist
•Steering system noise during operation
•Difficulty turning the steering wheel at low speeds

Diagnostic Steps

1
Check for any stored error codes using an OBD-II scanner.
2
Inspect the EPS fuse for continuity and replace if blown.
3
Verify power supply to the EPS module by checking voltage at the connector.
4
Inspect the EPS motor and wiring for damage or corrosion.
5
Perform a visual inspection of the steering column and associated components for physical obstruction.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Multimeter
•Torque wrench

Parts Required

•Replacement fuse (if necessary)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check for any stored error codes using an OBD-II scanner.
2
Inspect the EPS fuse for continuity and replace if blown.
3
Verify power supply to the EPS module by checking voltage at the connector.
4
Inspect the EPS motor and wiring for damage or corrosion.
5
Perform a visual inspection of the steering column and associated components for physical obstruction.

Solution

1. Preparation

Gather tools: OBD-II scanner, socket set, multimeter, torque wrench.
Ensure the vehicle is parked on a level surface with the engine off.
Disconnect the vehicle battery to prevent electrical shorts.

2. Resetting the Electric Power Steering

Reconnect the Battery:
- Reconnect the negative terminal of the battery after ensuring all connections are secure.
Turn the Ignition On:
- Insert the key and turn the ignition to the 'ON' position without starting the engine. This allows the EPS system to initialize.
Perform the Steering Wheel Calibration:
- Turn the steering wheel fully to the left and then fully to the right. Repeat this process two to three times to help the system recalibrate to its center position.
Clear Error Codes:
- Use the OBD-II scanner to clear any stored error codes related to the EPS. Follow the scanner's instructions to perform this action.
Test Drive the Vehicle:
- Start the engine and take the vehicle for a short drive to verify that the power steering assist is functioning correctly.