how to reset the tire pressure light in Ford F-150 Fourteenth Generation (2021-present)

Ford F-150 Fourteenth Generation (2021-present)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

438 words

Problem Statement

Learn how to reset the tire pressure light in your Ford F-150 (2021-present). Step-by-step instructions for diagnosing and resolving TPMS issues.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

•Ensure the vehicle is on a level surface to avoid any accidents during the process.

1
Check the tire pressures on all four tires using a reliable tire pressure gauge.
2
Inflate any under-inflated tires to the recommended pressure as specified on the driver's door jamb label.
3
Drive the vehicle for a short distance (approximately 10 minutes) to allow the TPMS system to recalibrate.
4
If the light remains on, attempt the reset procedure as outlined in the solution section.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Check the tire pressures on all four tires using a reliable tire pressure gauge.
2
Inflate any under-inflated tires to the recommended pressure as specified on the driver's door jamb label.
3
Drive the vehicle for a short distance (approximately 10 minutes) to allow the TPMS system to recalibrate.
4
If the light remains on, attempt the reset procedure as outlined in the solution section.

Solution

1. Preparation

Gather necessary tools (no special tools are required for this procedure).
Ensure all tires are inflated to the correct pressure.
Park the vehicle on a level surface and turn the ignition to the "On" position without starting the engine.

2. Resetting the TPMS

Locate the TPMS Reset Button
- The reset button is usually found beneath the steering wheel or near the instrument panel. Refer to the owner's manual if needed.
Press and Hold the TPMS Reset Button
- With the ignition in the "On" position, press and hold the TPMS reset button until the TPMS light in the dashboard blinks three times.
Release the TPMS Reset Button
- Release the button after the light has blinked. The TPMS light will remain on for a few seconds and then turn off.
Start the Vehicle
- Start the engine and let it run for a few minutes. The TPMS system should recalibrate, and the warning light should remain off.
Verify Tire Pressure
- After completing the reset, double-check the tire pressures to ensure they are at the recommended levels.