GMC Sierra T1XX (2019-Present) key fob not working, how can I fix it?

GMC Sierra T1XX (2019-Present)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

440 words

Problem Statement

Learn how to diagnose and fix a non-working key fob for GMC Sierra T1XX (2019-Present). Step-by-step instructions for battery replacement and reprogramming.

Affected Component

Electrical

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' before starting any procedures.

Symptoms

•Key fob buttons unresponsive
•Vehicle not recognizing the key fob
•Security indicator light blinking on the dashboard
•Inability to start the engine
•Low battery warning for key fob (if applicable)

Diagnostic Steps

1
Check the battery level of the key fob using a multimeter.
2
Replace the key fob battery and test functionality.
3
Verify if the vehicle recognizes the key fob by attempting to start the engine with the fob inside the vehicle.
4
Inspect the key fob for physical damage or water intrusion.
5
Scan the vehicle's computer for any related error codes using an OBD-II scanner.
6
Ensure that the key fob is programmed correctly to the vehicle.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small screwdriver
•Multimeter
•OBD-II scanner

Parts Required

•CR2032 battery for key fob

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check the battery level of the key fob using a multimeter.
2
Replace the key fob battery and test functionality.
3
Verify if the vehicle recognizes the key fob by attempting to start the engine with the fob inside the vehicle.
4
Inspect the key fob for physical damage or water intrusion.
5
Scan the vehicle's computer for any related error codes using an OBD-II scanner.
6
Ensure that the key fob is programmed correctly to the vehicle.

Solution

1. Preparation

Gather tools: small screwdriver (for battery replacement), multimeter, OBD-II scanner (if needed).
Ensure you are in a well-lit workspace.

2. Replace Key Fob Battery

Sub-steps:
1. Use a small screwdriver to gently pry open the key fob casing.
2. Remove the old battery, noting its orientation (+/-).
3. Insert a new battery (typically CR2032) in the same orientation.
4. Snap the key fob casing back together securely.

3. Reprogram Key Fob (if necessary)

Sub-steps:
1. Sit in the driver’s seat and close all doors.
2. Insert the key into the ignition and turn it to the "ON" position (do not start).
3. Press and hold the "LOCK" and "UNLOCK" buttons on the fob simultaneously for about 10 seconds.
4. Release both buttons and press the "LOCK" button again.
5. Turn the key to the "OFF" position and remove it from the ignition.

4. Verify Functionality

Sub-steps:
1. Test the key fob buttons to ensure they respond properly.
2. Attempt to start the vehicle with the key fob inside.