how to reset the check engine light on a GMC Sierra T1XX (2019-Present)

GMC Sierra T1XX (2019-Present)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

439 words

Problem Statement

Learn how to reset the check engine light on your GMC Sierra T1XX (2019-Present) with this step-by-step guide. Ensure your vehicle runs smoothly again.

Affected Component

Engine

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always ensure the vehicle is in park with the engine off when connecting the OBD-II scanner

Symptoms

•Check engine light illuminated on the dashboard
•Diagnostic trouble codes (DTCs) may be stored in the ECU
•Engine performance issues may have been present prior to light activation
•Possible decreased fuel efficiency
•Potential rough idling or stalling

Diagnostic Steps

1
Use an OBD-II scanner to check for stored diagnostic trouble codes (DTCs)
2
Address any underlying issues indicated by the DTCs (e.g., replace faulty sensors or components)
3
Clear the DTCs using the OBD-II scanner to reset the check engine light

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•Battery
•Sensor

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather all necessary tools and parts.
Ensure the vehicle is parked on a level surface and the engine is off.
Open the vehicle's hood and ensure the battery is in good condition.

2. Use OBD-II Scanner

Tools Required: OBD-II scanner
Locate the OBD-II port, typically found under the dashboard near the steering wheel.
Plug the OBD-II scanner into the port.
Turn the ignition to the "ON" position without starting the engine.

3. Read and Clear Codes

Follow the scanner's instructions to read the stored trouble codes.
Review the codes and ensure that the underlying issues have been resolved.
Select the option to clear or erase the trouble codes from the system.
Wait for the scanner to confirm that the codes have been cleared.

4. Verify Reset

Disconnect the OBD-II scanner from the port.
Start the engine and allow it to reach normal operating temperature.
Monitor the dashboard for the check engine light; it should remain off if the reset was successful.