how to reset the check engine light on my GMC Sierra T1XX (2019-Present)

GMC Sierra T1XX (2019-Present)

Error Codes

10-20 minutes

Time

easy

Difficulty

medium

Severity

2 min read

388 words

Problem Statement

Learn how to reset the check engine light on your GMC Sierra T1XX (2019-present) with this step-by-step guide. Ensure your vehicle runs smoothly.

Affected Component

Electrical

Estimated Time

10-20 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always follow the manufacturer's guidelines when using diagnostic tools.

Symptoms

•Check engine light illuminated
•Possible diagnostic trouble codes (DTCs) stored in the vehicle's computer
•No noticeable changes in vehicle performance

Diagnostic Steps

1
Use an OBD-II scanner to check for diagnostic trouble codes (DTCs) and identify any underlying issues.
2
Address any identified issues or repair any faults that triggered the check engine light.
3
Verify that the fault has been resolved before attempting to reset the light.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None specifically for resetting the check engine light

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools: OBD-II scanner and vehicle owner’s manual.
Ensure the vehicle is parked on a level surface with the engine off.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard, typically near the driver’s side.
Plug in the OBD-II scanner and turn the ignition key to the ON position without starting the engine.

3. Read and Clear Codes

Follow the OBD-II scanner's instructions to read the trouble codes.
Once noted, select the option to clear or erase the trouble codes.
Confirm the action on the scanner when prompted.

4. Disconnect Scanner

Once codes are cleared, safely disconnect the OBD-II scanner from the port.
Turn off the vehicle ignition and wait for a few seconds before restarting the engine.

5. Verify Reset

Start the engine and check if the check engine light is off.
If the light remains on, further diagnostics may be necessary to address unresolved issues.