how do I reset the maintenance light on my Honda Accord 9th Generation (2013-2017)

Honda Accord Eleventh Generation (2023-present)

Error Codes

Less than 15 minutes

Time

easy

Difficulty

low

Severity

2 min read

313 words

Problem Statement

Learn how to reset the maintenance light on your Honda Accord 9th Generation (2013-2017) with this step-by-step guide. Quick and easy instructions.

Affected Component

Electrical

Estimated Time

Less than 15 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and in a safe environment during the reset process.

Symptoms

•Maintenance light illuminated on the dashboard
•Vehicle owner unable to determine remaining maintenance intervals
•Incorrect service reminder notifications

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Press the 'Engine Start/Stop' button without pressing the brake pedal to turn on the electrical systems (but not the engine).
3
Locate the gas pedal and ensure it is accessible for the reset procedure.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Ensure all doors are closed and the vehicle is in a safe, stationary position.

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Reset Preparation

Tools Required: None
Ensure all doors are closed and the vehicle is in a safe, stationary position.

2. Accessing the Maintenance Reset Mode

Turn the ignition to the "ON" position (press the "Engine Start/Stop" button twice without pressing the brake).
Use the gas pedal: Fully depress the gas pedal three times within 5 seconds.

3. Confirming the Reset

After the third press of the gas pedal, the maintenance light should blink and then turn off.
Turn the ignition back to the "OFF" position.

4. Final Check

Start the engine to verify that the maintenance light is no longer illuminated.
If the light remains, repeat the reset procedure.