my Honda Accord has a grinding noise when turning what could be wrong

Honda Accord 9th Generation (2013-2017)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

506 words

Problem Statement

Learn how to diagnose and fix grinding noise when turning in Honda Accord. Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Steering

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always ensure the vehicle is securely lifted and supported on jack stands before working underneath it.
•Disconnect the battery before working on electrical components or systems.

Symptoms

•Grinding noise during left or right turns
•Vibration in the steering wheel
•Decreased steering responsiveness
•Unusual wear on tires
•Fluid leakage around the steering system

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Check for any visible damage or wear on the CV joints and boots.
3
Examine the wheel bearings for play or roughness by lifting the vehicle and spinning the wheel.
4
Inspect the suspension components (ball joints, tie rods, etc.) for wear or damage.
5
Test drive the vehicle to replicate the grinding noise and determine if it changes with speed or direction.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack
•Jack stands
•Socket set
•Torque wrench
•Screwdriver

Parts Required

•Power steering fluid
•CV joint or axle (if damaged)
•Wheel bearings (if needed)
•Suspension parts (if worn)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Check for any visible damage or wear on the CV joints and boots.
3
Examine the wheel bearings for play or roughness by lifting the vehicle and spinning the wheel.
4
Inspect the suspension components (ball joints, tie rods, etc.) for wear or damage.
5
Test drive the vehicle to replicate the grinding noise and determine if it changes with speed or direction.

Solution

1. Preparation

Gather tools: jack, jack stands, socket set, torque wrench, and a screwdriver.
Ensure the vehicle is on a flat surface and the engine is off.
Disconnect the battery if working on electrical components.

2. Inspect and Replace Power Steering Fluid

Remove the power steering fluid reservoir cap.
Check fluid level and condition; if dirty or low, drain and replace.
Refill with manufacturer-recommended power steering fluid.

3. Replace Damaged CV Joints

Lift the vehicle and secure it with jack stands.
Remove the wheel and tire.
Use a socket set to detach the CV axle from the transmission and hub.
Inspect the CV joint and boot; replace if damaged.
Reassemble by reversing the removal steps; ensure all fasteners are torqued to the manufacturer's specifications.

4. Replace Wheel Bearings (if needed)

Remove the brake caliper and rotor.
Use a socket set to remove the wheel bearing hub assembly.
Replace with a new wheel bearing and reassemble.
Ensure proper torque specifications are followed during reassembly.

5. Inspect and Replace Suspension Components (if necessary)

Check all suspension components for wear, focusing on ball joints and tie rods.
If any parts are worn, remove and replace them using the appropriate tools.
Ensure to align the suspension after replacements.