how to fix Honda Civic 10th Generation (2016-2021) key fob not working

Honda Civic 10th Generation (2016-2021)

Error Codes

30 minutes - 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

452 words

Problem Statement

Learn how to diagnose and fix a non-working key fob for Honda Civic 10th Generation (2016-2021). Step-by-step guide with symptoms and solutions.

Affected Component

Electrical

Estimated Time

30 minutes - 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Take care when using tools to avoid damaging the key fob.

Symptoms

•Key fob buttons unresponsive
•Unable to unlock or lock doors remotely
•Key fob warning light not illuminated
•Engine not starting with key fob present
•Physical key works but remote functions do not

Diagnostic Steps

1
Inspect the key fob for physical damage or wear.
2
Replace the battery in the key fob and test functionality.
3
Check for interference from other electronic devices in proximity.
4
Use a spare key fob (if available) to determine if the issue is with the fob or the vehicle's receiver.
5
Scan the vehicle for any error codes related to the keyless entry system using an OBD-II scanner.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Flathead screwdriver
•OBD-II scanner

Parts Required

•CR2032 battery

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the key fob for physical damage or wear.
2
Replace the battery in the key fob and test functionality.
3
Check for interference from other electronic devices in proximity.
4
Use a spare key fob (if available) to determine if the issue is with the fob or the vehicle's receiver.
5
Scan the vehicle for any error codes related to the keyless entry system using an OBD-II scanner.

Solution

1. Preparation

Gather tools and parts:
- Flathead screwdriver
- New CR2032 battery (or as specified for the model)
Ensure you are in a well-lit, clean workspace.

2. Replace Key Fob Battery

Open the Key Fob:
- Use the flathead screwdriver to gently pry open the key fob. Insert the screwdriver in the seam and twist to separate the halves.
Remove Old Battery:
- Carefully note the orientation of the old battery (positive side up) and remove it from the fob.
Install New Battery:
- Place the new CR2032 battery in the same orientation as the old one.
Reassemble the Key Fob:
- Align the two halves of the fob and press firmly until they click back together.

3. Reprogram Key Fob (if necessary)

Enter Programming Mode:
- Insert the key into the ignition and turn it to the ON position (do not start the engine).
- Press the lock button on the fob within 5 seconds.
Confirm Programming:
- Turn the key to OFF and remove it, then test the fob to see if it locks/unlocks the doors.