why does my Honda Civic 10th Generation (2016-2021) engine light keep coming on

Honda Civic 10th Generation (2016-2021)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

485 words

Problem Statement

Learn how to diagnose and fix the check engine light issue in Honda Civic 10th Generation (2016-2021). Step-by-step guide with symptoms and solutions.

Affected Component

Engine

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before performing any inspections or repairs.

Symptoms

•Check engine light illuminated
•Reduced engine performance or power
•Rough engine idle or misfires
•Increased fuel consumption
•Unusual engine noises or vibrations
•Possible emission-related warnings

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to retrieve stored trouble codes.
2
Inspect the gas cap for proper sealing and condition.
3
Check engine oil level and condition, ensuring it meets specifications.
4
Examine the air filter for blockages or excessive dirt.
5
Inspect vacuum hoses and connections for leaks or damage.
6
Test the battery voltage to ensure it is within normal operating range.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Screwdrivers

Parts Required

•Air filter
•Gas cap (if faulty)
•Vacuum hoses (if damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to retrieve stored trouble codes.
2
Inspect the gas cap for proper sealing and condition.
3
Check engine oil level and condition, ensuring it meets specifications.
4
Examine the air filter for blockages or excessive dirt.
5
Inspect vacuum hoses and connections for leaks or damage.
6
Test the battery voltage to ensure it is within normal operating range.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a level surface and the engine is cool.
Disconnect the battery's negative terminal to prevent electrical shorts.

2. Retrieve Error Codes

Connect the OBD-II scanner to the vehicle's diagnostic port.
Turn the ignition to the ON position without starting the engine.
Follow the scanner instructions to retrieve error codes.
Document any codes for further diagnosis.

3. Inspect and Replace Components

Gas Cap Check:
- Remove the gas cap and inspect for cracks or damage.
- Replace with a new gas cap if necessary.
Air Filter Replacement:
- Remove the air filter housing cover using a socket set.
- Take out the old air filter and install a new one.
- Reassemble the housing cover, ensuring a tight seal.
Vacuum Leak Check:
- Visually inspect hoses for cracks or disconnections.
- Replace any damaged hoses with new parts.

4. Reset Check Engine Light

After repairs, reconnect the battery's negative terminal.
Use the OBD-II scanner to clear any stored trouble codes.
Turn the ignition ON for a few seconds and then OFF to reset the system.