my Honda CR-V won't start and is making a clicking noise what could it be

Solution

1. Preparation

• Gather tools: multimeter, jumper cables, socket set, and a torque wrench.
• Ensure safety by wearing gloves and eye protection.

2. Battery Inspection

• Step 1: Disconnect the battery cables, starting with the negative terminal to avoid short circuits.
• Step 2: Clean the battery terminals using a wire brush to remove any corrosion.
• Step 3: Reconnect the battery terminals securely and ensure they are tight.

3. Jump-Start the Vehicle

• Step 1: Connect the jumper cables: positive to positive and negative to negative.
• Step 2: Start the donor vehicle and allow it to charge the battery for a few minutes.
• Step 3: Attempt to start the CR-V. If it starts, the issue is likely with the battery.

4. Starter Motor Testing

• Step 1: Disconnect the battery again for safety.
• Step 2: Locate the starter motor and check the connections for tightness and corrosion.
• Step 3: Use a multimeter to check for voltage at the starter solenoid while someone turns the ignition key.
• Step 4: If no voltage is present, further investigate the ignition switch or wiring.

5. Replace Components as Necessary

• If the battery is confirmed dead, replace it with a new one (ensure it matches the specifications).
• If the starter motor is faulty, replace it. Remove the starter by unbolting it from the engine and disconnecting the wiring, then install the new starter.