how to fix strut noise in Honda CR-V Fifth Generation (2017-2022)

Honda CR-V 6th Gen (2023-Present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

527 words

Problem Statement

Learn how to diagnose and fix strut noise in Honda CR-V (2017-2022). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is securely supported on jack stands before working underneath it.
•Always wear safety glasses when working with suspension components.

Symptoms

•Clunking or knocking noise over bumps
•Rattling sound when driving on uneven surfaces
•Excessive vibration felt through the steering wheel
•Reduced ride comfort
•Unusual tire wear patterns

Diagnostic Steps

1
Inspect strut mounts for signs of wear or damage.
2
Check for loose or damaged hardware in the strut assembly.
3
Examine the strut for any signs of leakage or physical damage.
4
Test drive the vehicle over various surfaces to isolate noise.
5
Verify proper alignment and suspension geometry.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Hydraulic jack
•Jack stands
•Lug wrench
•Socket set
•Torque wrench

Parts Required

•Strut assembly (if replacement is needed)
•Strut mounts (if worn or damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and parts.
Park the vehicle on a level surface and engage the parking brake.
Place wheel chocks behind the rear wheels for safety.

2. Lift the Vehicle

Use a hydraulic jack to lift the front of the vehicle.
Secure the vehicle with jack stands under the frame.

3. Remove the Wheel

Use a lug wrench to remove the lug nuts and take off the front wheel.
Ensure safety by placing the wheel under the vehicle for additional support.

4. Inspect and Replace Strut Components

Strut Mount Inspection:
1. Locate the strut mount at the top of the strut assembly.
2. Check for cracks or signs of wear; replace if necessary.
Strut Assembly Removal:
1. Remove bolts securing the strut to the steering knuckle using a socket set.
2. Disconnect any brake line brackets from the strut assembly.
3. Remove the top strut mount nuts using a socket.
4. Carefully extract the strut assembly from the vehicle.
Strut Replacement:
1. Compare the old strut with the new one to ensure correct fit.
2. Install the new strut by reversing the removal steps.
3. Torque the top mount nuts to the manufacturer’s specification (typically around 16-22 ft-lbs).

5. Reassemble and Lower Vehicle

Reattach the brake line brackets to the new strut.
Reinstall the wheel and hand-tighten the lug nuts.
Lower the vehicle and tighten the lug nuts to the manufacturer’s specification (typically around 80-100 ft-lbs).

6. Final Check

Conduct a visual inspection of the strut installation.
Ensure all components are properly secured and aligned.