how to reset the maintenance light on Honda Pilot YF3 (2016-2022)

Honda Pilot Third Generation (2016-present)

Error Codes

less than 10 minutes

Time

easy

Difficulty

low

Severity

2 min read

342 words

Problem Statement

Learn how to reset the maintenance light on Honda Pilot YF3 (2016-2022) with this easy step-by-step guide. No tools required, just follow the instructions.

Affected Component

Electrical

Estimated Time

less than 10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral and the parking brake is engaged before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Reminder message displayed on the multi-information display
•No other performance issues, as the light is purely a notification

Diagnostic Steps

1
Ensure the vehicle is parked and the ignition is in the OFF position.
2
Turn the ignition switch to the ON position without starting the engine.
3
Press the gas pedal three times within 10 seconds.
4
Check the multi-information display for the maintenance light status.
5
Turn the ignition off and then back on to confirm the reset.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required.

Parts Required

•None required.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is parked and the ignition is in the OFF position.
2
Turn the ignition switch to the ON position without starting the engine.
3
Press the gas pedal three times within 10 seconds.
4
Check the multi-information display for the maintenance light status.
5
Turn the ignition off and then back on to confirm the reset.

Solution

1. Preparation

Ensure the vehicle is parked on a flat surface.
Gather necessary tools: none required for this reset.

2. Ignition Position

Sit in the driver's seat and ensure all doors are closed.
Insert the key or press the start button to turn on the ignition without starting the engine (the dashboard lights should illuminate).

3. Reset the Maintenance Light

Locate the gas pedal.
Firmly press the gas pedal three times within a span of 10 seconds.
Observe the multi-information display to see if the maintenance light turns off.

4. Confirm the Reset

Turn the ignition switch to the OFF position.
Turn it back to the ON position (without starting the engine) to verify that the maintenance light is no longer illuminated.