how do I reset the tire pressure monitoring system in my Ram 1500 DT (2019-Present)?

Ram 1500 DT (2019-Present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

442 words

Problem Statement

Learn how to reset the Tire Pressure Monitoring System (TPMS) in your Ram 1500 DT (2019-Present) with this step-by-step guide. Ensure safety and accuracy.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked on a flat surface before performing the reset.

Symptoms

•Tire pressure warning light illuminated on the dashboard
•Inaccurate tire pressure readings displayed
•Warning message indicating low tire pressure
•Inconsistent tire pressure alerts after inflating tires

Diagnostic Steps

1
Check all tire pressures to ensure they are at the recommended levels.
2
Inspect each tire for any visible damage or leaks.
3
Verify that the spare tire, if equipped with a TPMS sensor, is also at the correct pressure.
4
Turn the ignition to the 'On' position without starting the engine.
5
Locate the TPMS reset button, typically found under the steering column or in the glove compartment.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Air pressure gauge

Parts Required

•None required unless TPMS sensors need replacement.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check all tire pressures to ensure they are at the recommended levels.
2
Inspect each tire for any visible damage or leaks.
3
Verify that the spare tire, if equipped with a TPMS sensor, is also at the correct pressure.
4
Turn the ignition to the 'On' position without starting the engine.
5
Locate the TPMS reset button, typically found under the steering column or in the glove compartment.

Solution

1. Preparation

Tools Required: None specifically required, but an air pressure gauge may be helpful.
Ensure all tires are inflated to the recommended pressure.

2. Reset the TPMS

Turn on the Ignition:
- Insert the key and turn the ignition to the "On" position without starting the engine.
- Wait for the dashboard lights to illuminate.
Locate the TPMS Reset Button:
- Find the TPMS reset button, which may be under the steering column or in the glove compartment. Consult the owner's manual for the exact location.
Press and Hold the TPMS Reset Button:
- Press and hold the TPMS reset button until the TPMS warning light blinks three times, then release the button.
Turn Off the Ignition:
- Turn the key to the "Off" position after the light blinks.
Start the Engine:
- Start the vehicle and allow it to run for about 20 minutes. This will allow the system to recalibrate.

3. Verify Tire Pressures

After the reset, check the tire pressures again to ensure they are correct. If needed, adjust any tire pressures to the recommended levels.