how to reset the check engine light in my Ram 1500 DT (2019-Present)

Ram 1500 DT (2019-Present)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

437 words

Problem Statement

Learn how to reset the check engine light in your Ram 1500 DT (2019-Present). Step-by-step guide with diagnostic procedures and tips for success.

Affected Component

Engine

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' with the parking brake engaged before working on the vehicle.

Symptoms

•Check engine light illuminated on the dashboard
•Possible stored diagnostic trouble codes (DTCs)
•Engine performance may be affected
•Rough idle
•Loss of power
•Vehicle may fail emission tests if applicable

Diagnostic Steps

1
Scan the vehicle for error codes using an OBD-II scanner to identify the underlying issue.
2
Address the root cause of the check engine light if any issues are found.
3
Clear the error codes using the OBD-II scanner to reset the check engine light.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None for the reset process; however, parts may be needed if faults are detected during diagnostics.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a flat surface.
Gather necessary tools including an OBD-II scanner.
Ensure the vehicle is turned off before connecting the scanner.

2. Connect OBD-II Scanner

Locate the OBD-II port, usually found under the dashboard near the driver's seat.
Plug the OBD-II scanner into the port.
Turn the vehicle's ignition to the "On" position without starting the engine.

3. Retrieve and Clear Codes

Follow the prompts on the OBD-II scanner to retrieve any diagnostic trouble codes (DTCs).
Record any active trouble codes for troubleshooting if needed.
Select the option to clear or erase codes on the scanner.
Confirm the action on the scanner when prompted.

4. Disconnect OBD-II Scanner

Once codes are cleared, safely disconnect the OBD-II scanner from the port.
Turn off the ignition and remove the key.

5. Test Drive the Vehicle

Start the engine and observe if the check engine light remains off.
Take the vehicle for a short drive to ensure the light does not reappear.