what does it mean if my Ram 1500 DT (2019-Present) has code C1010

Learn how to diagnose and fix C1010 steering angle sensor issues in Ram 1500 DT. Step-by-step guide with diagnostic procedures and repair instructions.

Solution

1. Preparation

• Tools Required: OBD-II scanner, multimeter, basic hand tools (sockets, wrenches), alignment tool.
• Ensure the vehicle is parked on a level surface and the ignition is off.
• Disconnect the battery to prevent any electrical shorts.

2. Inspect and Clean Connections

• Sub-steps:
  1. Locate the steering angle sensor, typically mounted on or near the steering column.
  2. Disconnect the sensor connector carefully.
  3. Inspect the connector pins for corrosion or dirt; clean with electrical contact cleaner if necessary.
  4. Reconnect the sensor ensuring a secure fit.

3. Calibrate Steering Angle Sensor

• Sub-steps:
  1. Reconnect the battery and turn the ignition to the "On" position without starting the engine.
  2. Use the OBD-II scanner to access the steering angle sensor calibration function.
  3. Follow the prompts to reset and calibrate the sensor.
  4. Confirm calibration is successful on the scanner.

4. Test Drive and Final Inspection

• Sub-steps:
  1. Start the engine and perform a short test drive, focusing on steering responsiveness.
  2. Monitor dashboard indicators for any warning lights.
  3. Use the OBD-II scanner again to check for any reoccurring codes.
  4. If successful, ensure all tools are collected and the area is clear.