how to reset service light on Renault Clio V (2019-Present)

Renault Clio V (2019-Present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

325 words

Problem Statement

Learn how to reset the service light on your Renault Clio V (2019-present) with this step-by-step guide. Quick and easy procedure to follow.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and in a safe environment while performing this reset.

Symptoms

•Service light illuminated on the dashboard
•Maintenance reminder displayed on the instrument cluster
•Vehicle may indicate that a service is due

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the keys are removed from the ignition.
2
Insert the key or press the start button (without starting the engine) to turn the ignition to the 'ON' position.
3
Locate the trip computer button on the stalk or the dashboard.
4
Press and hold the trip computer reset button until the service light flashes and then goes out.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required; just the vehicle key.

Parts Required

•None required for this procedure.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the keys are removed from the ignition.
2
Insert the key or press the start button (without starting the engine) to turn the ignition to the 'ON' position.
3
Locate the trip computer button on the stalk or the dashboard.
4
Press and hold the trip computer reset button until the service light flashes and then goes out.

Solution

1. Preparation

Gather necessary tools and ensure you are in a quiet environment to avoid distractions.
Ensure the vehicle is parked on a level surface and the ignition is off.

2. Ignition Position

Insert the key or press the start button to change the ignition position to "ON" without starting the engine.

3. Resetting the Service Light

Locate the trip computer button on the dashboard or the stalk.
Press and hold the trip computer button for approximately 10 seconds.
Observe the dashboard; the service light should flash and then turn off.