how can I reset the service light on my Tesla Outback 4th Generation (2010-2014)

Subaru Outback 4th Generation (2010-2014)

10-15 minutes

Time

easy

Difficulty

low

Severity

2 min read

364 words

Problem Statement

Learn how to reset the service light on your 2010-2014 Subaru Outback. Step-by-step instructions to clear maintenance reminders and warning lights.

Affected Component

Electrical

Estimated Time

10-15 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral with the parking brake applied before performing any ignition or pedal procedures.

1
Ensure the vehicle is parked on a level surface and the ignition is turned off.
2
Insert the key into the ignition and turn it to the 'ON' position without starting the engine.
3
Press the gas pedal three times within ten seconds.
4
Turn the ignition back to the 'OFF' position and remove the key.
5
Start the engine and check if the service light has been reset.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is parked on a level surface and the ignition is turned off.
2
Insert the key into the ignition and turn it to the 'ON' position without starting the engine.
3
Press the gas pedal three times within ten seconds.
4
Turn the ignition back to the 'OFF' position and remove the key.
5
Start the engine and check if the service light has been reset.

Solution

1. Preparation

Gather necessary tools: OBD-II scanner (if needed), owner's manual for reference.

2. Resetting the Service Light

Key Positioning
- Insert the key into the ignition.
- Turn the key to the "ON" position without starting the engine.
Accelerator Pedal Procedure
- Quickly press the accelerator pedal three times within ten seconds.
- Ensure that you press it fully to the floor each time for the reset to register.
Ignition Off
- After completing the accelerator pedal steps, turn the ignition switch to the "OFF" position.
- Remove the key from the ignition.
Engine Start
- Start the engine to verify that the service light is no longer illuminated.