how to reset the check engine light for my Tesla Outback 5th Generation (2015-2019)

Subaru Outback 5th Generation (2015-2019)

Error Codes

30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

378 words

Problem Statement

Learn how to reset the check engine light on your 2015-2019 Tesla Outback. Step-by-step guide with diagnostic procedures and tools required.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral with the parking brake engaged while performing this procedure.

Symptoms

•Check engine light illuminated
•Potential fault codes stored in the vehicle’s computer
•Vehicle runs without noticeable performance issues

Diagnostic Steps

1
Use an OBD-II scanner to check for any stored error codes.
2
Record the error codes and diagnose the underlying issues if necessary.
3
Ensure all issues triggering the check engine light have been resolved.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Vehicle owner’s manual

Parts Required

•None required for resetting the check engine light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather tools: OBD-II scanner, vehicle owner’s manual.
Ensure the vehicle is parked on a level surface and the engine is off.

2. Connect OBD-II Scanner

Locate the OBD-II port beneath the dashboard near the driver's seat.
Plug the OBD-II scanner into the port.

3. Read Error Codes

Turn the ignition to the "ON" position without starting the engine.
Follow the scanner’s instructions to read the error codes.
If the codes are related to a resolved issue, proceed to the next step.

4. Clear Error Codes

On the scanner, navigate to the option to clear or erase error codes.
Confirm the selection to reset the check engine light.
Wait for the scanner to confirm the codes have been cleared.

5. Disconnect Scanner

Safely remove the OBD-II scanner from the port.
Turn off the ignition.

6. Test Drive

Start the vehicle and take it for a short drive to ensure the check engine light remains off.