how to fix P0130 code on Tesla Model S Plaid/Refresh (2021-present)

Learn how to diagnose and fix P0130 oxygen sensor circuit issues in Tesla Model S Plaid. Step-by-step guide with diagnostic procedures and repair instructions.

Solution

1. Preparation

• Ensure the vehicle is parked on a level surface and the parking brake is engaged.
• Disconnect the negative terminal of the battery to prevent any electrical shorts.
• Gather necessary tools and parts.

2. Inspect and Replace Oxygen Sensor

• Tools Required:

  • Oxygen sensor socket
  • Ratchet and extension
  • Torque wrench
  • Multimeter

• Sub-steps:

  1. Locate the upstream oxygen sensor on the exhaust manifold.
  2. Using the oxygen sensor socket, carefully remove the old oxygen sensor by turning it counterclockwise.
  3. Inspect the sensor threads and the wiring harness for damage.
  4. Apply anti-seize compound to the threads of the new oxygen sensor if required.
  5. Install the new oxygen sensor by threading it into the exhaust manifold and tightening it to the manufacturer's specified torque (typically around 30 ft-lbs).
  6. Reconnect the electrical connector to the new oxygen sensor.

3. Reconnect Battery and Clear Codes

• Reconnect the negative terminal of the battery.
• Use the OBD-II scanner to clear the P0130 code from the vehicle's computer.

4. Test Drive

• Start the vehicle and allow it to reach operating temperature.
• Take the vehicle for a test drive to ensure proper operation and monitor for any return of the check engine light.