how to replace the wiper blades on a Tesla Model S Original (2012-2020)

Tesla Model S Plaid/Refresh (2021-present)

Error Codes

15-30 minutes

Time

easy

Difficulty

low

Severity

3 min read

425 words

Problem Statement

Learn how to replace wiper blades on Tesla Model S (2012-2020). Step-by-step guide with symptoms, diagnostic steps, and installation instructions.

Affected Component

Body/Interior

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the wiper arms are held securely when lifted to prevent them from snapping back onto the windshield.

Symptoms

•Streaks or smears on the windshield while using wipers
•Wipers skipping or chattering during operation
•Worn or torn rubber on the wiper blades
•Noisy operation of the wipers
•Reduced visibility during rain or snow

Diagnostic Steps

1
Inspect the wiper blades visually for signs of wear or damage.
2
Test the wipers to observe their performance on the windshield.
3
Check the wiper arm movement to ensure they are not obstructed.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Lift the wiper arm away from the windshield until it locks in a vertical position.
•Locate the release tab on the wiper blade where it attaches to the wiper arm.

Parts Required

•Two new wiper blades compatible with Tesla Model S (2012-2020)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and parts.
Park the vehicle in a safe location and ensure the windshield is clean.
Turn on the ignition and activate the wipers to the "off" position for easy access.

2. Remove Old Wiper Blades

Tools Required: None
Lift the wiper arm away from the windshield until it locks in a vertical position.
Locate the release tab on the wiper blade where it attaches to the wiper arm.
Press the release tab while sliding the wiper blade downwards to detach it from the arm. Repeat for the other blade.

3. Install New Wiper Blades

Tools Required: None
Take the new wiper blade and align it with the wiper arm.
Slide the wiper blade onto the arm until it clicks into place, ensuring it is securely attached.
Gently lower the wiper arm back onto the windshield. Repeat the process for the second wiper blade.

4. Final Check

Tools Required: None
Ensure both blades are securely attached and in the correct position.
Conduct a test run of the wipers to verify proper operation.