how to resolve P0011 timing issue in Tesla Model S Original (2012-2020)

Learn how to diagnose and fix P0011 timing issue in Tesla Model S (2012-2020). Step-by-step guide with diagnostic procedures and repair instructions.

Solution

1. Preparation

• Ensure the vehicle is parked on a flat surface and the ignition is off.
• Disconnect the negative battery terminal to prevent electrical shorts.

2. Change Engine Oil

• Sub-steps:
  1. Gather required tools (socket set, oil filter wrench, oil catch pan).
  2. Remove the oil drain plug and allow the old oil to fully drain.
  3. Replace the oil filter.
  4. Install a new oil drain plug and tighten to the manufacturer’s specifications (typically 25 lb-ft).
  5. Refill the engine with the recommended oil type (5W-30 or as specified in the owner's manual).

3. Replace VVT Solenoid (if faulty)

• Sub-steps:
  1. Remove any necessary engine covers to access the VVT solenoid.
  2. Disconnect the electrical connector from the VVT solenoid.
  3. Remove the mounting bolts (typically a 10mm socket) and take out the solenoid.
  4. Install the new VVT solenoid and torque the bolts to manufacturer specifications.
  5. Reconnect the electrical connector.

4. Check Timing Chain/Belt

• Sub-steps:
  1. Remove the engine front cover using the appropriate socket set.
  2. Inspect the timing chain/belt for wear or misalignment.
  3. Realign or replace the timing components as necessary, following the manufacturer's guidelines for timing marks.
  4. Reinstall the engine cover and torque the bolts to specifications.

5. Clear Codes and Test Drive

• Sub-steps:
  1. Reconnect the negative battery terminal.
  2. Use the OBD-II scanner to clear the P0011 code.
  3. Test drive the vehicle under various conditions to ensure the issue is resolved.

Tools Required:

• OBD-II scanner
• Socket set (including 10mm socket)
• Oil filter wrench
• Torque wrench
• Oil catch pan

Parts Required:

• Engine oil (5W-30 or as specified)
• Oil filter
• VVT solenoid (if faulty)

Estimated Repair Time: 3-5 hours

Safety Warnings:

• Disconnect the battery before working on electrical systems.
• Allow the engine to cool before working on any components to prevent burns.