how to reset the maintenance light on my Toyota Camry Eighth Generation (2018-present)

Toyota Camry Eighth Generation (2018-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

393 words

Problem Statement

Learn how to reset the maintenance light on your Toyota Camry (2018-2023) with this step-by-step guide. Quick and easy instructions included.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' and on a flat surface before performing the reset

Symptoms

•Maintenance light illuminated on the dashboard
•No other warning lights illuminated
•Reminder for oil change or service due displayed

Diagnostic Steps

1
Gather necessary tools (key fob or ignition key)
2
Ensure the vehicle is in the 'OFF' position
3
Insert the key and turn it to the 'ON' position without starting the engine
4
Locate the trip meter reset button on the dashboard
5
Press and hold the trip meter reset button

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Ignition key
•Key fob

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a level surface.
Have the ignition key or key fob ready.

2. Accessing the Maintenance Light Reset

Turn the Ignition On:
- Insert the key into the ignition and turn it to the "ON" position (do not start the engine).
Set the Trip Meter:
- Locate the trip meter reset button on the instrument cluster.
- Press the button until the trip meter reads "Trip A."

3. Resetting the Maintenance Light

Press and Hold the Reset Button:
- With the trip meter on "Trip A," press and hold the trip meter reset button.
- Keep holding it until the maintenance light starts to blink and then turns off (approximately 10 seconds).
Turn Off the Ignition:
- Release the trip meter reset button.
- Turn the ignition off.

4. Verification of Reset

Start the Engine:
- Start the engine to ensure the maintenance light is off.
Check for Warning Lights:
- Confirm that the maintenance light does not illuminate during the start-up sequence.