how to reset the tire pressure light on my Toyota Camry Eighth Generation (2018-present)

Toyota Camry Eighth Generation (2018-present)

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

400 words

Problem Statement

Learn how to reset the tire pressure light on your Toyota Camry (2018-2023). Step-by-step guide with diagnostic procedures and reset instructions.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

1
Verify that all tires, including the spare, are inflated to the manufacturer's recommended pressure.
2
Check for any visible damage or leaks in the tires.
3
Ensure that the ignition is in the 'ON' position without starting the engine.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Solution

1. Preparation

2. Reset TPMS

Turn on the ignition:
- Insert the key and turn it to the "ON" position without starting the engine.
Locate the TPMS reset button:
- The reset button is usually located beneath the steering wheel or near the driver's side door. Consult the owner's manual if necessary.
Press and hold the TPMS reset button:
- Hold the button until the tire pressure light blinks three times, then release it.
Check the tire pressures again:
- After resetting, ensure all tires are still at the correct pressure.
Start the engine:
- Turn the ignition to the "START" position and let the vehicle run for a few minutes to allow the system to recheck the tire pressures.

3. Final Checks

After driving for a short distance, verify that the tire pressure warning light remains off.