why does my Toyota Camry Eighth Generation (2018-present) airbag light keep coming on

Solution

1. Preparation

• Gather necessary tools and parts.
• Ensure the vehicle is parked on a level surface and the ignition is off.
• Disconnect the battery (negative terminal) and wait for at least 10 minutes to ensure the airbag system is deactivated.

2. Inspect Wiring and Connectors

• Remove the lower dash panel to access airbag connectors.
• Visually inspect all airbag-related wiring for fraying, cuts, or corrosion.
• Disconnect and reconnect connectors to ensure a secure fit.
• Replace any damaged wiring or connectors as necessary.

3. Check Airbag Control Module

• Locate the airbag control module, typically found under the driver's seat or behind the center console.
• Inspect the module for any physical damage or corrosion.
• Use a multimeter to check the power and ground circuits to the module for continuity.
• If the module is faulty, replace it with a new one, following the manufacturer's specifications.

4. Test Seatbelt Sensors

• Inspect the seatbelt buckle sensors for any signs of damage or wear.
• If necessary, replace any malfunctioning seatbelt sensors.
• Clear any stored DTCs using the OBD-II scanner.

5. Reconnect Battery and Test

• Reconnect the negative terminal of the battery.
• Turn the ignition key to the "ON" position without starting the engine and observe if the airbag light goes off.
• Start the engine and perform a test drive to ensure the airbag system is functioning correctly.