how to reset the maintenance light on my Toyota Corolla E140 (2006-2013)?

Toyota Corolla E140 (2006-2013)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

348 words

Problem Statement

Learn how to reset the maintenance light on your 2006-2013 Toyota Corolla E140 with this simple step-by-step guide. Quick and easy instructions.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe location with the engine off before performing the reset procedure.

1
Ensure the vehicle is in the 'OFF' position with the key removed from the ignition.
2
Insert the key into the ignition and turn it to the 'ON' position without starting the engine.
3
Locate the odometer button on the dashboard.
4
Press and hold the odometer button until the trip meter displays '000000.'
5
Turn the ignition switch to the 'OFF' position again.
6
Turn the ignition switch back to the 'ON' position while continuing to hold the odometer button until the maintenance light blinks and goes out.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position with the key removed from the ignition.
2
Insert the key into the ignition and turn it to the 'ON' position without starting the engine.
3
Locate the odometer button on the dashboard.
4
Press and hold the odometer button until the trip meter displays '000000.'
5
Turn the ignition switch to the 'OFF' position again.
6
Turn the ignition switch back to the 'ON' position while continuing to hold the odometer button until the maintenance light blinks and goes out.

Solution

1. Preparation

2. Reset Maintenance Light

Insert the key into the ignition.
Turn the key to the "ON" position, but do not start the engine.
Press and hold the odometer button until the trip meter shows "000000."
Turn the ignition switch to the "OFF" position.
Turn the ignition switch back to the "ON" position while continuing to hold the odometer button.
Wait until the maintenance light flashes and then extinguishes, indicating a successful reset.