how to fix a clicking noise when turning in my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

477 words

Problem Statement

Learn how to diagnose and fix clicking noise when turning in Toyota Corolla E170. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Ensure the vehicle is securely supported on jack stands before working underneath.

Symptoms

•Clicking or popping sound when turning the steering wheel
•Noise is more pronounced during sharp turns
•Vibration felt through the steering wheel
•Possible grease leakage around the CV joint area
•Increased noise when accelerating while turning

Diagnostic Steps

1
Inspect the CV joints for visible damage or torn boots.
2
Check the condition of the wheel bearings for wear or play.
3
Examine the suspension components, including control arms and bushings, for any signs of wear.
4
Lift the vehicle and rotate the front wheels to listen for any unusual noises.
5
Test drive the vehicle to confirm if the noise occurs under specific conditions.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•CV joint puller
•Torque wrench
•Pry bar
•Wheel chocks

Parts Required

•New CV joint assembly
•New axle nut (if recommended)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the CV joints for visible damage or torn boots.
2
Check the condition of the wheel bearings for wear or play.
3
Examine the suspension components, including control arms and bushings, for any signs of wear.
4
Lift the vehicle and rotate the front wheels to listen for any unusual noises.
5
Test drive the vehicle to confirm if the noise occurs under specific conditions.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is on a flat surface and use wheel chocks to prevent rolling.
Disconnect the battery to avoid electrical issues.

2. Inspect CV Joints

Tools Required: Socket set, pry bar, torque wrench
Remove the front wheel using a socket set.
Carefully inspect the CV joint boot for tears or grease leakage.
If damaged, proceed to the next step for replacement.

3. Remove and Replace CV Joint

Tools Required: CV joint puller, torque wrench, socket set
Remove the axle nut using a socket set.
Use a CV joint puller to detach the CV joint from the hub.
Remove the axle from the transmission by pulling it out carefully.
Install the new CV joint by reversing the removal process:
1. Insert the new axle into the transmission.
2. Attach the CV joint to the hub and secure it with the axle nut.
3. Torque the axle nut to the manufacturer’s specification (usually around 150 ft-lb).

4. Reassemble and Test

Reinstall the wheel and lower the vehicle.
Reconnect the battery.
Test drive the vehicle to ensure the clicking noise is resolved.