how to reset the check engine light on my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

364 words

Problem Statement

Learn how to reset the check engine light on your 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and tools required.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems if you choose to do so.

Symptoms

•Check engine light illuminated
•Possible stored trouble codes
•Engine may run normally or exhibit symptoms related to the underlying issue

Diagnostic Steps

1
Use an OBD-II scanner to read and record any trouble codes.
2
Address any underlying issues indicated by the trouble codes.
3
Clear the trouble codes using the OBD-II scanner.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None specifically required for the reset process (ensure vehicle issues are resolved).

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required: OBD-II scanner
Ensure the vehicle is parked on a flat surface and the engine is off.
Open the hood and disconnect the battery for additional safety (optional).

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard on the driver's side.
Plug the OBD-II scanner into the port and turn the ignition to the "ON" position without starting the engine.

3. Read Trouble Codes

Follow the instructions on the OBD-II scanner to read any trouble codes.
Write down the codes for reference and possible repair.

4. Clear Trouble Codes

Use the scanner to clear the trouble codes.
Follow the prompt on the scanner to complete the reset.

5. Disconnect OBD-II Scanner

Once the codes are cleared, disconnect the scanner from the OBD-II port.
If the battery was disconnected, reconnect it.

6. Test Drive

Start the vehicle and take it for a short drive to ensure the check engine light remains off.