how to reset the maintenance light on a Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

318 words

Problem Statement

Learn how to reset the maintenance light on a 2013-2019 Toyota Corolla E170. Follow our step-by-step guide for a quick and easy reset.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' mode to prevent unintended movement while performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Check engine light may also be present if other issues exist
•Notification of scheduled maintenance overdue may be displayed

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the key is removed from the ignition.
2
Insert the key into the ignition without starting the engine.
3
Press the gas pedal fully down three times within five seconds.
4
Turn the ignition to the 'ON' position without starting the engine.
5
Observe if the maintenance light blinks and then turns off.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Vehicle key

Parts Required

•None required for the reset process.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the key is removed from the ignition.
2
Insert the key into the ignition without starting the engine.
3
Press the gas pedal fully down three times within five seconds.
4
Turn the ignition to the 'ON' position without starting the engine.
5
Observe if the maintenance light blinks and then turns off.

Solution

1. Preparation

Gather necessary tools, including the vehicle key.
Ensure the vehicle is parked on a level surface and in "Park" mode.

2. Ignition Sequence

Insert the vehicle key into the ignition.
Turn the key to the "ON" position without starting the engine (all warning lights should illuminate).
Fully depress the gas pedal three times within five seconds.

3. Confirm Reset

Turn the ignition back to the "OFF" position.
Start the vehicle to confirm that the maintenance light has been reset and is no longer illuminated.