how to reset the maintenance light on my Toyota Corolla E170 (2013-2019)?

Toyota Corolla E170 (2013-2019)

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

294 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2019 Toyota Corolla E170 with this simple step-by-step guide. Quick and easy instructions.

Affected Component

Electrical

Estimated Time

5 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a flat surface before beginning the reset procedure

1
Ensure the vehicle is turned off before starting the reset process
2
Insert the key into the ignition but do not start the engine
3
Press the odometer button until the trip meter displays 'Odo'
4
Turn the ignition switch to the 'ON' position while continuing to hold the odometer button
5
Continue holding the odometer button until the maintenance light flashes and then turns off

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is turned off before starting the reset process
2
Insert the key into the ignition but do not start the engine
3
Press the odometer button until the trip meter displays 'Odo'
4
Turn the ignition switch to the 'ON' position while continuing to hold the odometer button
5
Continue holding the odometer button until the maintenance light flashes and then turns off

Solution

1. Preparation

2. Ignition and Display Reset

Insert Key: Place the key into the ignition.
Odometer Setting: Press and hold the odometer button on the instrument panel.
Ignition Position: Turn the ignition to the "ON" position without starting the engine.
Wait for Light Reset: Keep holding the odometer button until the maintenance light flashes and then turns off. This usually takes about 10 seconds.