how to reset the maintenance light on Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

355 words

Problem Statement

Learn how to reset the maintenance light on a 2013-2019 Toyota Corolla E170. Step-by-step guide for a quick and easy reset.

Affected Component

Electrical

Estimated Time

5 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' with the parking brake engaged before performing the reset.

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the trip meter reset button on the instrument panel.
3
Turn the ignition switch to the 'ON' position without starting the engine.
4
Continue holding the trip meter reset button until the maintenance light begins to blink and then turns off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Solution

1. Preparation

2. Resetting the Maintenance Light

Locate the Trip Meter Reset Button
- Find the trip meter reset button on the instrument cluster (usually located near the odometer).
Press and Hold the Button
- Press and hold the trip meter reset button.
Turn the Ignition ON
- While holding the button, turn the ignition switch to the "ON" position (do not start the engine).
Observe the Maintenance Light
- Keep holding the reset button until the maintenance light blinks and then turns off, indicating a successful reset.
Release the Button
- Once the maintenance light is off, release the trip meter reset button.