how to reset the maintenance light on Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

less than 10 minutes

Time

easy

Difficulty

low

Severity

2 min read

314 words

Problem Statement

Learn how to reset the maintenance light on a 2013-2019 Toyota Corolla E170. Follow our step-by-step guide for a quick and easy solution.

Affected Component

Electrical

Estimated Time

less than 10 minutes

Important safety information - read before proceeding

1
Ensure the vehicle is in the 'OFF' position.
2
Insert the key into the ignition (do not start the engine).
3
Press and hold the trip meter reset button on the instrument panel.
4
Turn the ignition to the 'ON' position while holding the trip meter button.
5
Continue holding the trip meter button until the maintenance light blinks and then turns off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Insert the key into the ignition (do not start the engine).
3
Press and hold the trip meter reset button on the instrument panel.
4
Turn the ignition to the 'ON' position while holding the trip meter button.
5
Continue holding the trip meter button until the maintenance light blinks and then turns off.

Solution

1. Preparation

2. Resetting the Maintenance Light

Insert the key into the ignition without starting the engine.
Press and hold the trip meter reset button located on the instrument panel.
While continuing to hold the trip meter button, turn the ignition key to the "ON" position (do not start the engine).
Keep holding the trip meter button until the maintenance light blinks and then turns off (this may take about 10 seconds).
Release the trip meter reset button.