how to reset the tire pressure warning light on Toyota Corolla E170 (2013-2019)?

Toyota Corolla E170 (2013-2019)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

409 words

Problem Statement

Learn how to reset the tire pressure warning light on a 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and solutions.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always check tire pressures when the tires are cold for the most accurate readings.

Symptoms

•Tire pressure warning light illuminated on the dashboard
•Possible uneven tire wear
•Decreased fuel efficiency
•Handling issues during driving

Diagnostic Steps

1
Check the tire pressures of all four tires with a tire pressure gauge.
2
Inflate or deflate the tires to the recommended pressure as specified in the owner’s manual or on the driver's door jamb.
3
Inspect for any visible damage or punctures in the tires that may indicate a loss of pressure.
4
Verify if the spare tire (if applicable) also has a pressure monitoring sensor and check its pressure.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•Inflator

Parts Required

•None (unless tire pressure sensors need replacement)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check the tire pressures of all four tires with a tire pressure gauge.
2
Inflate or deflate the tires to the recommended pressure as specified in the owner’s manual or on the driver's door jamb.
3
Inspect for any visible damage or punctures in the tires that may indicate a loss of pressure.
4
Verify if the spare tire (if applicable) also has a pressure monitoring sensor and check its pressure.

Solution

1. Preparation

Ensure all tires are at the correct recommended pressure.
Gather the following tools:
- Tire pressure gauge
- Inflator (if needed)

2. Reset the Tire Pressure Monitoring System (TPMS)

Turn on the Ignition:
- Insert the key and turn the ignition to the "ON" position without starting the engine.
Locate the TPMS Reset Button:
- Find the TPMS reset button, usually located beneath the steering wheel or near the driver's side kick panel.
Press the TPMS Reset Button:
- Press and hold the TPMS reset button until the tire pressure warning light blinks three times, then release the button.
Turn Off the Ignition:
- Turn the ignition off completely.
Start the Engine:
- Start the engine and check if the tire pressure warning light has turned off.

3. Final Check

If the warning light remains illuminated, repeat the reset procedure or consult a professional for further diagnostics.