my Toyota Corolla E170 (2013-2019) shakes when I brake is this normal

Toyota Corolla E170 (2013-2019)

Error Codes

2-4 hours

Time

medium

Difficulty

high

Severity

3 min read

464 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to diagnose and fix brake shaking in Toyota Corolla E170 (2013-2019). Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Brakes

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always disconnect the battery before working on electrical components.
•Allow brake components to cool before handling.

Symptoms

•Steering wheel vibration during braking
•Pulsation felt in the brake pedal
•Vehicle pulling to one side while braking
•Uneven wear on brake pads or rotors
•Possible noise from the brake components

Diagnostic Steps

1
Inspect brake rotors for warping or scoring.
2
Check brake pad condition for uneven wear.
3
Examine suspension and steering components for wear or damage.
4
Verify wheel alignment and balance.
5
Scan for any error codes related to braking systems.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•Dial indicator gauge
•Bungee cord

Parts Required

•Brake rotors (if warped)
•Brake pads (if worn)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather all necessary tools and parts.
Ensure the vehicle is parked on a level surface and engage the parking brake.
Wear safety glasses and gloves.

2. Lift the Vehicle

Use a jack to raise the front of the vehicle.
Secure with jack stands for safety.

3. Remove Wheel

Use a socket set to remove lug nuts.
Take off the wheel to access the brake components.

4. Inspect and Replace Brake Rotors (if needed)

Check for rotor warping using a dial indicator gauge.
If warped, remove the caliper by unbolting it and hanging it with a bungee cord (do not let it hang on the brake line).
Remove the rotor by unbolting it from the hub.
Install new rotors, ensuring they are torqued to manufacturer specifications (typically around 70-90 ft-lbs).

5. Inspect and Replace Brake Pads (if needed)

Remove the brake pads from the caliper bracket.
Check for uneven wear; replace if necessary.
Install new pads, ensuring to lubricate the backing with brake grease.

6. Reassemble and Lower Vehicle

Reattach the caliper over the new pads.
Reinstall the wheel and hand-tighten the lug nuts.
Lower the vehicle and torque the lug nuts to manufacturer specifications (usually 76-80 ft-lbs).

7. Test Brakes

Pump the brake pedal to ensure pads seat correctly before driving.