why does my Toyota Corolla E170 (2013-2019) make a popping sound when I turn?

Toyota Corolla E170 (2013-2019)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

462 words

Problem Statement

Learn how to diagnose and fix popping sounds when turning in a 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is securely lifted and supported before working underneath it.
•Always wear safety glasses and gloves when handling mechanical components.

Symptoms

•Popping or clicking noise during turns
•Noise occurs when turning left or right
•Possible vibrations felt in the steering wheel
•Uneven tire wear observed
•Decreased steering responsiveness

Diagnostic Steps

1
Inspect the front suspension components for visible damage or wear.
2
Check the CV joints for signs of wear or damage, particularly the boots for tears.
3
Test the steering rack and tie rods for play or looseness.
4
Examine the wheel bearings for any signs of noise or roughness when rotated.
5
Evaluate the tires for proper inflation and alignment issues.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•Pliers
•Screwdrivers

Parts Required

•CV joint (if damaged)
•Suspension components (if found to be worn)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the front suspension components for visible damage or wear.
2
Check the CV joints for signs of wear or damage, particularly the boots for tears.
3
Test the steering rack and tie rods for play or looseness.
4
Examine the wheel bearings for any signs of noise or roughness when rotated.
5
Evaluate the tires for proper inflation and alignment issues.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a level surface and secure with wheel chocks.
Disconnect the negative battery terminal to prevent electrical issues.

2. Inspect and Replace CV Joints

Lift the vehicle: Use a jack and jack stands to elevate the front of the car safely.
Remove the wheel: Take off the front wheel to access the CV joint.
Inspect the CV joint: Check for torn boots or any grease leakage. If damaged, proceed to replace it.
Remove the old CV joint:
- Unscrew the retaining bolts connecting the CV joint to the wheel hub.
- Slide the CV joint off the axle.
Install the new CV joint:
- Align the new CV joint with the axle and secure it using the retaining bolts. Torque to the manufacturer’s specification (typically around 30-40 ft-lbs).

3. Check and Replace Suspension Components

Inspect suspension parts: Look for worn or damaged control arms, bushings, and struts.
Replace damaged components:
- Use a socket set to remove bolts from failing components.
- Install new parts and torque to manufacturer specifications.
Reassemble: Reattach the wheel and lower the vehicle.