how to reset my Toyota Corolla E210 (2019-2024) tire pressure monitoring system?

Toyota Corolla E210 (2019-2024)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

417 words

Problem Statement

Learn how to reset the TPMS on your 2019-2024 Toyota Corolla E210. Step-by-step instructions to resolve tire pressure monitoring system issues.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

•Ensure the vehicle is parked on a flat surface and the engine is off before performing any maintenance.

1
Check the tire pressure of all tires, ensuring they are inflated to the recommended PSI as indicated on the door jamb label.
2
Inspect each tire for visible damage or punctures that might be affecting tire pressure.
3
Verify if the TPMS light resets automatically after correcting tire pressures.
4
If the light remains on, determine if the reset procedure is needed as per the owner's manual.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Check the tire pressure of all tires, ensuring they are inflated to the recommended PSI as indicated on the door jamb label.
2
Inspect each tire for visible damage or punctures that might be affecting tire pressure.
3
Verify if the TPMS light resets automatically after correcting tire pressures.
4
If the light remains on, determine if the reset procedure is needed as per the owner's manual.

Solution

1. Preparation

2. Reset TPMS

Turn on the Ignition:
- Insert the key into the ignition and turn it to the "ON" position without starting the engine. If your model has a push-button start, press the start button twice without pressing the brake pedal.
Locate the TPMS Reset Button:
- Find the TPMS reset button, usually located beneath the steering wheel or near the driver's side dashboard.
Press and Hold the TPMS Reset Button:
- Press and hold the reset button until the TPMS warning light blinks three times, then release it.
Start the Vehicle:
- Turn the ignition off and start the vehicle to ensure the TPMS light is no longer illuminated.
Drive the Vehicle:
- Drive the vehicle for approximately 10 to 30 minutes at speeds over 25 mph to allow the system to recalibrate.