how to reset the maintenance light on my Toyota Corolla E210 (2019-2024)?

Toyota Corolla E210 (2019-2024)

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

420 words

Problem Statement

Learn how to reset the maintenance light on your 2019-2024 Toyota Corolla E210. Step-by-step guide to ensure your vehicle is ready for the road.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is parked in a safe location and the engine is off before performing the reset.

1
Ensure the vehicle is parked in a safe location with the engine turned off.
2
Turn the ignition key to the 'ON' position without starting the engine.
3
Locate the odometer display and ensure it is showing the total mileage.
4
Turn off the ignition.
5
Press and hold the 'Trip' or 'Odo' button while turning the ignition back to the 'ON' position.
6
Continue to hold the button until the maintenance light flashes and then turns off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is parked in a safe location with the engine turned off.
2
Turn the ignition key to the 'ON' position without starting the engine.
3
Locate the odometer display and ensure it is showing the total mileage.
4
Turn off the ignition.
5
Press and hold the 'Trip' or 'Odo' button while turning the ignition back to the 'ON' position.
6
Continue to hold the button until the maintenance light flashes and then turns off.

Solution

1. Preparation

Ensure all maintenance tasks are completed (e.g., oil change, filter replacement).
Gather necessary tools (if needed, for maintenance tasks).

2. Resetting the Maintenance Light

Turn Ignition On:
- Turn the ignition key to the "ON" position without starting the engine or press the "Start" button twice.
Display Setup:
- Check that the odometer is showing the total mileage.
- If it is not, toggle the display using the "Trip" button until it shows the total mileage.
Power Off:
- Turn off the ignition completely.
Button Press:
- Press and hold the "Trip" or "Odo" button.
Turn Ignition On Again:
- While holding the button, turn the ignition back to the "ON" position.
Observe the Maintenance Light:
- Continue to hold the button until the maintenance light on the dashboard flashes and then turns off.
Release the Button:
- Release the "Trip" or "Odo" button.