how to reset the tire pressure light on Toyota Corolla E210 (2019-2024)

Toyota Corolla E210 (2019-2024)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

407 words

Problem Statement

Learn how to reset the tire pressure light on your 2019-2024 Toyota Corolla E210. Step-by-step guide with diagnostic steps and tools required.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

1
Check tire pressures: Use a tire pressure gauge to measure the tire pressures of all four tires, ensuring they are set to the recommended levels.
2
Inspect for leaks: Look for any visible signs of damage or punctures in the tires that may cause low pressure.
3
Verify the spare tire: If equipped, check that the spare tire is properly inflated if the vehicle uses a full-size spare that is monitored by the TPMS.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

•None specifically for the reset, but ensure proper tire maintenance supplies are available.

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Check tire pressures: Use a tire pressure gauge to measure the tire pressures of all four tires, ensuring they are set to the recommended levels.
2
Inspect for leaks: Look for any visible signs of damage or punctures in the tires that may cause low pressure.
3
Verify the spare tire: If equipped, check that the spare tire is properly inflated if the vehicle uses a full-size spare that is monitored by the TPMS.

Solution

1. Preparation

Ensure all tires are inflated to the manufacturer's recommended pressure.
Gather necessary tools: tire pressure gauge, OBD-II scanner (if needed for advanced systems).

2. Resetting the TPMS

Locate the TPMS reset button:
- The reset button is usually located beneath the steering wheel or on the lower dashboard. Refer to the owner's manual for exact location.
Start the vehicle:
- Turn the ignition to the "ON" position without starting the engine, or start the engine.
Press and hold the reset button:
- Press and hold the TPMS reset button until the tire pressure light blinks three times, then release the button.
Drive the vehicle:
- Drive the vehicle for at least 10 minutes at speeds above 25 mph to allow the system to recalibrate and confirm that the tire pressures are correct.