how to reset the check engine light on my Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

Error Codes

30 minutes

Time

medium

Difficulty

medium

Severity

3 min read

413 words

Problem Statement

Learn how to reset the check engine light on your 2014-2019 Toyota Highlander. Step-by-step guide with diagnostic steps and safety tips.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the engine is off before connecting or disconnecting the OBD-II scanner.

Symptoms

•Check engine light illuminated
•Possible recent changes in vehicle performance
•Potential error codes stored in the vehicle's computer
•Vehicle may experience rough idling or decreased fuel efficiency
•No abnormal noises or vibrations noted

Diagnostic Steps

1
Use an OBD-II scanner to read and record any stored error codes.
2
Inspect the vehicle for any obvious issues such as loose gas cap or damaged hoses.
3
Clear error codes using the OBD-II scanner to reset the check engine light.
4
Drive the vehicle for a short distance to ensure the check engine light does not reappear.
5
Recheck for error codes after driving to confirm if the issue has been resolved.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None (assuming no underlying issues are present)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Use an OBD-II scanner to read and record any stored error codes.
2
Inspect the vehicle for any obvious issues such as loose gas cap or damaged hoses.
3
Clear error codes using the OBD-II scanner to reset the check engine light.
4
Drive the vehicle for a short distance to ensure the check engine light does not reappear.
5
Recheck for error codes after driving to confirm if the issue has been resolved.

Solution

1. Preparation

Gather necessary tools: OBD-II scanner.
Ensure the vehicle is parked on a level surface and the engine is turned off.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard on the driver's side (typically near the steering column).
Plug the OBD-II scanner into the port.

3. Read Error Codes

Turn on the vehicle's ignition (do not start the engine) to power the scanner.
Follow the scanner’s prompts to read and record any error codes.

4. Clear Error Codes

Select the option to clear or erase the error codes on the OBD-II scanner.
Confirm the action when prompted to reset the check engine light.

5. Test Drive

Start the engine and allow it to idle for a few minutes.
Take the vehicle for a short drive (approximately 10-15 minutes) to observe if the check engine light reactivates.