how to reset the maintenance light on my Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

Error Codes

less than 10 minutes

Time

easy

Difficulty

low

Severity

2 min read

357 words

Problem Statement

Learn how to reset the maintenance light on your Toyota Highlander (2014-2019) with this easy step-by-step guide. Ensure your vehicle is ready for the road.

Affected Component

Electrical

Estimated Time

less than 10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' and on a level surface before beginning the reset process.

Symptoms

•Maintenance light illuminated on the dashboard
•Notification message displayed on the multi-information display
•Reminder for oil change or other scheduled service appears

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the trip meter reset button on the dashboard.
3
While holding the trip meter button, turn the ignition to the 'ON' position (do not start the engine).
4
Continue to hold the trip meter reset button until the maintenance light resets (usually takes a few seconds).
5
Release the trip meter reset button.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required

Parts Required

•None required

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the trip meter reset button on the dashboard.
3
While holding the trip meter button, turn the ignition to the 'ON' position (do not start the engine).
4
Continue to hold the trip meter reset button until the maintenance light resets (usually takes a few seconds).
5
Release the trip meter reset button.

Solution

1. Preparation

Gather necessary tools: None required for this process.
Ensure the vehicle is parked with the ignition off.

2. Reset Maintenance Light

Press and hold the trip meter reset button located on the dashboard.
Turn the ignition key to the "ON" position without starting the engine. This can be done by turning the key to the second click.
Keep holding the trip meter reset button until the maintenance light begins to flash and then turns off (typically takes about 5 seconds).
Release the trip meter reset button once the maintenance light goes off.

3. Verify Reset

Turn the ignition off and then back on to confirm the maintenance light remains off.