how to reset the maintenance light on my Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

366 words

Problem Statement

Learn how to reset the maintenance light on your 2014-2019 Toyota Highlander. Step-by-step guide for a quick and easy reset after maintenance.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and the ignition is turned off before starting the reset process to avoid any accidental starting of the engine.

Symptoms

•Maintenance light is illuminated on the dashboard
•Warning message displayed in the multi-information display
•Vehicle maintenance completed (oil change, filter replacement, etc.)

Diagnostic Steps

1
Turn the ignition switch to the 'OFF' position.
2
Press and hold the odometer trip reset button on the dashboard.
3
While holding the trip reset button, turn the ignition switch to the 'ON' position (do not start the engine).
4
Continue holding the trip reset button until the maintenance light turns off, which usually takes about 10 seconds.
5
Release the trip reset button once the light is off.
6
Turn the ignition switch back to the 'OFF' position and then back to 'ON' to ensure the light remains off.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition switch to the 'OFF' position.
2
Press and hold the odometer trip reset button on the dashboard.
3
While holding the trip reset button, turn the ignition switch to the 'ON' position (do not start the engine).
4
Continue holding the trip reset button until the maintenance light turns off, which usually takes about 10 seconds.
5
Release the trip reset button once the light is off.
6
Turn the ignition switch back to the 'OFF' position and then back to 'ON' to ensure the light remains off.

Solution

1. Preparation

Gather necessary tools (if needed):
- None required for this procedure.

2. Reset Maintenance Light

Ensure the vehicle is in a safe, stationary position with the ignition off.
Press and hold the odometer trip reset button located on the instrument panel.
While holding the button, turn the ignition switch to the "ON" position without starting the engine.
Keep the button pressed until the maintenance light turns off, which may take approximately 10 seconds.
Once the light is off, release the trip reset button.

3. Verification of Reset

Turn the ignition switch to the "OFF" position.
Turn the ignition back to the "ON" position without starting the engine.
Confirm that the maintenance light is no longer illuminated on the dashboard.