how to reset the tire pressure light on my Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

455 words

Problem Statement

Learn how to reset the tire pressure light on your 2014-2019 Toyota Highlander. Step-by-step guide with diagnostic procedures and tips for maintaining tire pressure.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always check tire pressures when the tires are cold for the most accurate reading.

Symptoms

•Tire pressure warning light illuminated on the dashboard
•Tire pressure may be low or inconsistent
•Possible uneven tire wear if not addressed
•Reduced fuel efficiency due to improper tire inflation

Diagnostic Steps

1
Check all tire pressures using a reliable tire pressure gauge.
2
Inflate or deflate tires to the manufacturer's recommended pressure, which can be found on the driver's side door jamb.
3
Inspect each tire for visible damage or leaks.
4
Ensure the spare tire is also checked, as it may be monitored by the TPMS (Tire Pressure Monitoring System).

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•Air compressor
•OBD-II scanner

Parts Required

•None required for the reset process; however, consider TPMS sensor replacement if issues persist.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check all tire pressures using a reliable tire pressure gauge.
2
Inflate or deflate tires to the manufacturer's recommended pressure, which can be found on the driver's side door jamb.
3
Inspect each tire for visible damage or leaks.
4
Ensure the spare tire is also checked, as it may be monitored by the TPMS (Tire Pressure Monitoring System).

Solution

1. Preparation

Ensure that all tires, including the spare, are correctly inflated to the recommended levels.
Gather necessary tools:
- Tire pressure gauge
- Air compressor (if needed for inflation)

2. Resetting the Tire Pressure Light

Locate the TPMS Reset Button:
- The TPMS reset button is usually located under the steering wheel or near the driver's side dashboard.
Turn on the Ignition:
- Insert the key and turn it to the "ON" position without starting the engine. For push-start models, press the start button twice without pressing the brake pedal.
Press and Hold the TPMS Reset Button:
- Press and hold the TPMS reset button until the tire pressure light blinks 3 times, then release the button.
Wait for the Light to Turn Off:
- Start the vehicle and allow it to run for a few minutes. The tire pressure light should turn off. If it remains on, repeat the reset procedure.
Check for Error Codes (if light remains on):
- Use an OBD-II scanner to diagnose any underlying issues with the TPMS.